Cleanflight SP Racing F3 Flight Controller
* Cleanflight 32-bit open source software
* STM32F3 CPU
* High capacity flash on both Acro and Deluxe versions
* MPU6050 accelerometers and gyroscopes
* MS5611 barometer (Deluxe version)
* HMC5883 compass (Delux version)
* Micro USB socket
* 4 x 4 pin JST-SH socket (I2C, SWD, 2xuart)
* 2 x 8 pin JST-SH socket (PPM, PWM, SERIAL RX, GPIO, ADC, 3V, 5V, GND)
* 8 x 3 pin through holes for ESC and servo connections
* 2 x 4 pin through holes for the 2x serial ports
* 2 x 2 pin through holes for battery voltage monitors or buzzers
* Supports ONESHOT ESCs
* 3 built in PID controllers
* RGB LED strip support for FPV racing and night flying
* Autotune feature
* In flight PID tuning
* Blackbox flight data recording
Superior Flight Performance:
* Fly your FPV racing drone like it is a race car on rails!
No Compromise I/O:
* Enough power to use all the features all the time! Connect your OSD + SmartPort + SBUS + GPS + LED Strip + Battery Monitoring + Sonar + 8 motors all at one, all at the same time!
* The SP F3 runs Cleanflight which can be configured to suit your needs using a cross-platform GUI (Windows/OSX/Linux).
Compact and Lightweight:
* The RacingF3 has a standard 36x36mm form-factor with 30.5mm mounting holes and weighs just 6 grams.
Black Box Flight Recording:
* On-board high capacity black box flight log recorder - optimize your tuning and see the results of your setup without guesswork.
Twice As Fast Next Generation CPU:
* The RacingF3 has an ARM Cortex-M4 72Mhz CPU with math co-processor (FPU) for efficient flight calculations that gets more done in less time.
* Loop times up to ~2x as fast as previous-generation STM32F1 based boards!
* Like to hack? Developer friendly debugging port (SWD) and boot mode selection, unbrickable bootloader.
Sharper Response With ONESHOT ESC:
* Full support for OneShot ESCs! Easy PID tuning and a sharper responses.
Broad RC Radio Support:
* Built in support for SBUS, SumH, SumD, Spektrum1024/2048, XBus, PPM, PWM receivers. No external receiver inverters required.
Programmable LED Control:
* Program your LEDs using the dedicated output for LEDs. Take control of your LED display for flight orientation, FPV racing or night flying.
* Battery monitoring ports for both voltage and current.
* Sonar support for precision low-altitude hold.
Power On I2C:
* I2C port always powered, perfect for external sensors or always on OLED Screen.
* Buzzer port for audible warnings and notification
1 x Cleanflight SP Racing F3 Flight Controller (Acro 6DOF or Deluxe 10DOF)
(Includes pins and wire harness)